Specification for nickel-chromium-titanium-aluminium heat-resisting alloy bar and wire (maximum diameter or minor sectional dimension of 30 mm) for the manufacture of fasteners (nickel base, Cr 19.5, Ti 2.2, Al 1.4) best-seller It defines the fundamental concepts

It defines the fundamental concepts of the verification process

as well as a consistent and reproducible means of evaluating the compliance with these requirements by laboratory testing using static loading on a representative specimen

and marking of steel

BS EN 13598-1:2010 Plastics piping systems for non-pressure underground drainage and sewerage

Specification for nickel-chromium-titanium-aluminium heat-resisting alloy bar and wire (maximum diameter or minor sectional dimension of 30 mm) for the manufacture of fasteners (nickel base, Cr 19.5, Ti 2.2, Al 1.4) best-seller It defines the fundamental concepts1 Scope This British Standard specifies requirements for nickel chromium titanium aluminium heat resisting alloy in the following forms, for the manufacture of fasteners. a) Bar and wire for machining: cold worked and solution treated, designation HR 601A. b) Bar and wire for continuous cold forging or cold extrusion: cold worked and softened, designation HR 601B. c) Bar and wire for hot upset forging: cold worked, designation HR 601C.