Victron - Argofet 200-2 Two batteries 200A [ARG200201020] Smart / Skylla-S Chargers and Mains Cords

Victron - Argofet 200-2 Two batteries 200A [ARG200201020] Smart / Skylla-S Chargers and Mains CordsSimilarly to Argodiode battery isolators, Argofet isolators allow simultaneous charging of two or more batteries from one alternator (or a single output battery charger), without connecting the batteries together. In contrast with Argodiode battery isolators, Argofet isolators have virtually no voltage loss. Voltage drop is less than 0,02 Volt at low current and averages 0,1 Volt at higher currents.

240VAC is only available when the MultiPlus is supplied by a split phase 120/240VAC source

The new metal case design and fully covered electrical connections improve the safety and modernise the presentation in line with the latest suite of Victron products

or current from a charger

• Waterproof Shore Power Cable and Inlet IP56

MultiPlus-II

a screw ring for mounting

It can operate with a battery voltage as low as 0 Volts

Power (VA) and calculate energy of a PV Inverter connected to the AC input or output of a Multi or Quattro

with the capability to utilise the full 50A for charging and AC loads

The 2 meter extension cable is an accessory of the Blue Smart IP65 Charger with DC connector

these dynamos (powered by the on-board electronics of Euro 5 and 6 engines) do not always emit the correct charging current

The GX Tank 140 is compatible with current senders (4 to 20 mA) as well as voltage senders (0 to 10 V)