1966 Electric Choke Conversion Tri-power Engine Compartment

1966 Electric Choke Conversion Tri-power Engine CompartmentIf you have blocked the runner in the heads, or the crossover and have lost your choke, this may be what you need. I use parts from other early Rochester carbs to mount a choke cup (same as 59 to 65 center carbs) where the pull off would have mounted. I modify this the cup to accept vacuum from the same source on the throttle body the 66 pull off uses. You do not have to remove the 66 choke shaft. This is a bolt on. All screws, gaskets and parts you

You need to glass bead all surfaces prior to assembly

I carry tthis special bolt and washer in Stainless Steel under another listing on the page or add as an option with the choke stove at a savings

11- photos attached of various customer locations

There are a pair of 5/16" posts threaded into the intake between the center and rear carbs

New white plastic choke diaphragm and plated bracket

or are building a "clone" center carb

Studs have the correct 5/16-18 threads into intake and 5/16-24 up on top

if you should need to replace your small center carburetor float this is the item

Also have one other F-fitting available that is metal in the shopping cart

These here are orginal water pumps with casting # 9772716 used on the 1964 and 1965 years

throttle blades and have the levers attached on both the passenger and drivers side

They hit you with an additional charge to order the pump rod