Three Manual Die Cutters for 1"x1" Split Pouch Cell - MSK-T-3 Convection Oven

Three Manual Die Cutters for 1"x1" Split Pouch Cell - MSK-T-3 Convection OvenMSK T 3 is one set of manual die cutters (Three cutters per set) to prepare the electrodes and separator for MTI 1x1" Split Pouch Cell. it is perfectly suitable for the single layer pouch cell battery R&D at a low cost and gets more consistent results than a coin cell SPECIFICATIONS Cutting Dies Dimension Three dies are preinstalled in the cutters separately to match MTI 1x1" Split Pouch Cell Anode cutting die (mm): L25. 4 mm x W 25. 4 mm Separator

Resistivity :                  0

F=P_(Gauge Displayed Pressure Value (GDPV)) ×S_(Cross-section area of the inside piston)

Polytetrafluoroethylene (PTFE) is a synthetic fluoropolymer of tetrafluoroethylene which is consisting wholly of carbon and fluorine

1/4" feedthrough for thermocouple inserted  and 1/8 NPS valve  with installed  Mechanical Pressure Gauge

One piece of 50160 aluminum case

Clicking thumb picture to enlarge

Water Flow Requirement Minimum water flow 150-200 cc/min

Size:            10mm x 10mm x 1

PP (Polypropylene) sealing O-ring

340 mm x  6 mm (The sealing blade depth and width could be customized at an extra cost)

Core wire diameter 0

Specific Surface Area (m2/g)