Flat Recess Dimple Die 7/16" Apache Just twist them out like

Just twist them out like a model car piece or cut them out with a small air saw

or even butt welded directly to a flat panel to appear as if it was always part of that panel

**Introducing Exhaust Fab Blocks by Hammer Fab**

and proper driveline geometry with a smooth

Flat Recess Dimple Die 7/16" Apache Just twist them out likeThese are the best quality made in the USA dimple dies available. Flat Recess Dimple Dies are great for making a fastener sit just a little bit below the surface of your panel or flip it over and it can be just a little higher than your panel. These add substantial strength to the panel as well as a clean, detailed look. These particular dies are rated for 16ga mild steel. These 17 16" dies may be installed with an impact driver or hydraulic press.