1980 Gibson Tim Shaw Humbucker (PAT NO. 2737842) Cello Strings

1980 Gibson Tim Shaw Humbucker (PAT NO. 2737842) Cello Strings1980 Gibson Tim Shaw Humbucker (PAT NO. 2737842) As an engineer at the Gibson Custom Shop, Tim Shaw was appointed the job of recreating the golden era of PAF humbuckers in the early 1980s for use in Gibson guitars, following feedback that the "PAF" clones manufactured in the 1970s were pretty far off the mark. The result was the Tim Shaw PAT NO. humbucker you see before you, manufactured for a short time between 1980 1986. These are often considered

Not only is this guitar a spectacle in design

8K* Neck Polarity: Reversible with 2-Conductor Lead Bridge Polarity: Reversible with 2-Conductor Lead Magnet: USA-Made Bonded Neodymium Wire: USA-Made 43 Gauge Single Poly Nylon Bobbin Material: USA-Made Nylon Injection Mold Recommended Pot Value: 500K String Spacing: 50mm * Due to the unique design of this pickup

Clean and Dirty channels can be switched on the amp’s top panel or remotely using the optional footswitch

you may find yourself leaving this on the entire gig

the original frets have little to no wear on them and the guitar has only minor finish swirling and a few dents in the finish

Model: EP-10

MIDI IN connector allows synchronization with external MIDI sequencer or control of the RT-123 from other MIDI equipment

• Up to 90 feet of wireless range (dependent on environmental factors)

height set the zero fret

Roland JUNO-6 Analog Synthesizer

34 Mandolin - Phos Bronze - Light These phosphor bronze mandolin strings sound clear

• Chorus/Vibrato: Switch to Chorus or Vibrato