Neurosurgical implants. Sterile, single-use hydrocephalus shunts and components Ingestion-build-61878

Neurosurgical implants. Sterile, single-use hydrocephalus shunts and components Ingestion-build-618781 Scope This International Standard specifies safety and performance requirements for sterile, single use non active hydrocephalus shunts and components. This includes the components used in shunts, like valves, tubes and reservoirs. This International Standard gives no recommendation concerning the superiority of a certain type of valve. For manufacturing, it defines the mechanical and technical requirements. This International Standard defines the

BS EN 1995-1-2 is intended for clients (e

BS 4444 on electrical earth monitoring and protective conductor is relevant to:

• Confidentiality is optional

protective systems and components are operated in line with their intended use and are installed and maintained according to the relevant codes of practice or requirements

foam stability

is applicable as the basis for the design

consisting of one base coat

The Vehicle Interface Service shall publish two services

The diagnostic tests employed in the fixed time frame method are restricted to destructive tests

The resolution of a pointing device is given in relation to four levels of index of difficulty for the Fitts test

even a short-term exposure to water can be sufficient to weaken the adhesion of a coating film either to the substrate or within the coating system

Note: These systems are embedded or can be connected to a software application capable of consolidating data and delivering automatic analysis